Black 7 Color Water Temperature Gauge

GlowShift’s Black 7 Color Series Water Temperature Gauge allows you to easily monitor your engines coolant temperature ensuring it does not over heat, resulting in major engine damage. This water temperature gauge reads from 100 to 300 degrees Fahrenheit with the included 1/8th NPT electronic temperature sensor. GlowShift’s Water Temperature Gauge features an illuminated red needle that sweeps 270 degrees, and is powered by stepper motor technology ensuring all needle movement is smooth and your gauge readings are extremely accurate. This gauge also features a magnified lens, as well as 7 color through dial lighting. GlowShift’s 7 Color through dial lighting allows you to closely match your vehicles factory dash lights or add a custom look to your interior. Our 7 color through dial LED lighting system lets the user easily cycle through 7 solid color modes, along with 2 color cycle modes, and for easier night driving the LEDs can be dimmed 30% when connected to your factory headlight switch. With the included color memory recall feature you don’t need to worry about adjusting the color of your gauge every time you turn your vehicle on. The included 1/8th NPT electronic temperature sensor is easily installed using either a Water Temperature Sensor Adapter or t-fitting, both of which can be found in the water temperature adapter section of the website. GlowShift stands behind all of its products by including free lifetime technical support and a one year limited warranty with every gauge purchase

• 2 1/16 Inch (52mm) Black Face Gauge with a Magnified Lens
• Water Temperature Reading from 100 to 300 Degrees Fahrenheit
• 7 Color LED Through Dial Lighting with Color Recall Ability
• 7 Solid Color Settings and Two Color Cycle Modes
• Dimmer Wire Allows the Gauge to Dim 30%
• Electronic Water Temperature Sensor with 1/8th NPT Male Threads
• Mounting Hardware
• Installation Instructions
• Free Lifetime Technical Support
• One Year Limited Warranty

Optional 7 Color Series Extended Wire Harness allows you to easily install and power your gauges. This wire harness replaces the included 18 inch lead wires, and effortlessly snaps into the back of your 7 Color Series Gauge using the featured modular connector, giving you 3 ½ feet of power wire and 10 feet of sensor wire so no additional wire extensions should be needed.