Awesome part. I like the factory look and not having to cut up the dash and running pillar pods just don't work for me. If you want gauges where you can see them this is the answer. Leaves some space to see fuel level and engine coolant temps on the factory gauge cluster. Durable plastic made to replace the stock cluster surround. Holds dual gauges 2 1/16"size. Goes good with my gauge that was installed previously. The cruise control switch below the cluster houses the 3rd gauge. GlowShift gauges fit perfectly and others as I tried some other makes to check fitment issues. Has the pre-drilled screw holes up top and one on the bottom just like factory bezel although I didn't use the bottom one. does go in kinda tight just make sure to take ya time and the steering column is set low. If pillar pods aren't for you this is your answer. If ya have Integra DA DC2 get this to install bezel fits snug and on DC2 chassis the wiring fits perfect underneath wire both gauges in a series and down through small opening under the bezel to the fuse box. Makes the gauge install a 9-10 as 10 being the easiest being you have to take few pieces off the dash and remove the stock bezel. Buying again as I own 2 Acura Integras.