GlowShift's Replacement 2 Post 0-100 PSI Fuel Pressure Sensor is equipped with 2 thumb screws where “m” is for ground and “g” is for the green signal wire that is part of the gauge harness. The sensor has a 1/8-27 NPT male thread for an easy connection to the pressure source. The length is 3 1/4” with a diameter of 1 3/4”. This sender is identified by its silver color and a black sticker that says "Fuel Press Sender".
Please refer to the chart below to see if this sensor is compatible with your gauge.
7 Color Gauge Series
Tinted Gauge Series
Blue & Red Digital Gauge Series
Installed May of 2016
Sender and gauge have worked flawlessly. What I thought was a bad sending unit ended up being a bad ground. Good tech support
Posted by brian greenway on
100 psi fuel pressure sending unit
low cost, when checked with manual gage it is correct pressure, only problem I have had it it fails after about 1 1/2 years and goes to max pressure, I have replaced the unit twice now.whic is only reason for 4 star, other than short lifespan (sender) I'm happy with glow shift gauges, they seem to read the correct pressures and look nice.
Posted by Dan on